Plugin downloaded 11558 times.
Creates a bolt and a nut and washer between two components. The definition of the nut and bolt assemblies is limited to the bolt diameter, head type, and washer locations. The overall length is determined by the thickness of the two component parts.
To use, run plugin and select the top and bottom component parts. Select an edge on the top component then define or keyin the desired offset and left click. Select an adjacent edge and again define or keyin the desired offset and left click. The nut and bolt assembly is created as a group and placed at the intersection of the offsets defined.
How to install: Just drop it in Plugins folder.
UI Location: Plugins
SketchUp version: 7
Added to the site on 19 September 2011
Comments are disabled.